XG 350 V6-3.5L (2002)
6. Evenly apply a light coat of glass primer to the windshield glass and then let it dry for 1 to 15 minutes.
NOTE:
1. Do not apply body primer to the glass.
2. The primer strengthens the adhesive, so be sure to apply it evenly around the entire circumference.
Also, a too thick application will weaken the adhesive.
3. Never touch the primed surface with your hands.
If you do, the adhesive may not bond to the glass properly, causing a leak after the windshield glass is installed.
4. Keep water, dust, and abrasive materials away from the primer.
7. Glue the rubber dam to the inside surface of the windshield glass around the edge as shown, to contain the sealant during installation.
8. Apply a light coat of body primer to the original sealant remaining around the window opening flange. The glass should be installed 10 minutes
after you apply the primer.
9. Pack adhesive into the cartridge avoiding air pockets, to ensure continuous application. Put the cartridge in a caulking gun or sealant gun, and run