G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
Sunroof / Moonroof Module: Testing and Inspection
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
MEMORY RESET PROCEDURE
1. Please observe the following instructions at confirming the sunroof operation.
NOTE: Do not disconnect the electronic power while the sunroof is operating or within 5 seconds after the sunroof stops. (to wipe-out the
memory of lid position and operating friction.)
2. Initialization of system should be conducted after the following conditions.
-
When the sunroof motor is changed.
-
When the sunroof does not operate normally. (Incomplete initialization conditions)
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement
INITIALIZATION PROCEDURE
If the sunroof does not close or open automatically, use the following procedure to return sunroof operation to normal.
1. Push the tilt up switch and start the tilt up operation.
2. Release the tilt up switch once, press the tilt up switch again, keep pushing the switch until lid pops up.
3. The glass lid will more toward tilt up direction and will be stopped mechanically, and then it will be automatically fully closed. (keep pushing the
switch during this operation)
4. Release the switch again, and push the tilt up switch within the first 10 seconds. (keep pushing the switch)
5. After 4 seconds, the glass lid will be automatically operated in sequence of tilt down, slide open and slide close.
6. After the glass lid stops, release the switch 0.5 second later. (keep pressing the switch during this operation)
7. If slide switch operates normally, this initialization is done.
ANTI-PINCH FUNCTION
1. Full open the sunroof.
2. Place a piece of wood near fully closed position.
3. Close the sunroof completely with auto-slide close.
Check that sunroof lowers for approximately 150mm or 2 seconds with out pinching a piece of wood and stops.
CAUTION:
-
Do not check with hands and other part of body because they may be pinched. Do not get pinched.
-
Depending on environment and driving conditions, if a similar impact or lord is applied to the sunroof it may lower.
-
Check that auto-slide operates before inspection when system initialization is performed.
-
Perform initial setting when auto-slide operation or anti-pinch function does not operate normally.