G37 Coupe V6-3.7L (VQ37VHR) (2008)
3. Remove oil strainer.
4. Loosen mounting bolts in the reverse order as shown in the figure with power tool to remove.
<---: Engine front
^
Insert the seal cutter [SST: KV10111100 (J37228)] between oil pan (upper) and lower cylinder block. Slide seal cutter by tapping on the side
of tool with a hammer. Remove oil pan (upper).
CAUTION:
^
Be careful not to damage the mating surfaces.
^
Never insert a screwdriver, because this damages the mating surfaces.
5. Remove O-rings (2) from bottom of lower cylinder block (1) and oil pump (3).
<---: Engine front
INSTALLATION
1. Install oil pan (upper) as follows:
a. Use a scraper (A) to remove old liquid gasket from mating surfaces.
CAUTION:
Never scratch or damage the mating surfaces when cleaning off old liquid gasket.
^
Also remove old liquid gasket from mating surface of lower cylinder block.
^
Remove old liquid gasket from the bolt holes and threads.