G37 Coupe V6-3.7L (VQ37VHR) (2008)
b. Install new O-rings (2) on the bottom of lower cylinder block (1) and oil pump (3).
<---: Engine front
c. Apply a continuous bead of liquid gasket with the tube presser (commercial service tool) to the cylinder block mating surface of oil pan
(upper) to a limited portion as shown in the figure.
a: 4.0 - 5.0 mm (0.157 - 0.197 in)
<---: Engine front
Use Genuine RTV Silicone Sealant or equivalent.
CAUTION:
^
For bolt holes with [triangle] marks (7 locations), apply liquid gasket outside the holes.
^
Attaching should be done within 5 minutes after coating.
d. Install oil pan (upper).
CAUTION:
Never misalign both O-rings during installation.
^
Tighten mounting bolts in numerical order as shown in the figure.
<---: Engine front
^
There are two types of mounting bolts. Refer to the following for locating bolts.
M8 x 90 mm (3.54 in): 7, 10, 13
M8 x 25 mm (0.98 in): Except the above
2. Install oil strainer to oil pump.
3. Install oil pan (lower).
4. Install oil pan drain plug.
^
Refer to the figure of components on the prior page for installation direction of drain plug washer.
5. Install in the reverse order of removal after this step.
NOTE: