M35 V6-3.5L (VQ35HR) (2009)
Multiple Junction Connector: Description and Operation
HARNESS CONNECTOR
Description
HARNESS CONNECTOR (TAB-LOCKING TYPE)
-
The tab-locking type connectors help prevent accidental looseness or disconnection.
-
The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the figure below.
CAUTION:
Never pull the harness or wires when disconnecting the connector.
[Example]
HARNESS CONNECTOR (SLIDE-LOCKING TYPE)
-
A new style slide-locking type connector is used on certain systems and components, especially those related to OBD.
-
The slide-locking type connectors help prevent incomplete locking and accidental looseness or disconnection.
-
The slide-locking type connectors are disconnected by pushing or pulling the slider. Refer to the figure below.
CAUTION:
-
Never pull the harness or wires when disconnecting the connector.
-
Be careful not to damage the connector support bracket when disconnecting the connector.
[Example]
HARNESS CONNECTOR (LEVER LOCKING TYPE)
-
Lever locking type harness connectors are used on certain control units and control modules such as ECM, ABS actuator and electric unit (control
unit), etc.
-
Lever locking type harness connectors are also used on super multiple junction (SMJ) connectors.
-
Always confirm the lever is fully locked in place by moving the lever as far as it will go to ensure full connection.
CAUTION:
Always confirm the lever is fully released (loosened) before attempting to disconnect or connect these connectors to avoid damage to the
connector housing or terminals.