Amigo 2WD L4-2.3L (4ZD1) (1989)
Wheel Bearing: Adjustments
Fig. 15 Exploded view of automatic locking hub assembly
Automatic Locking Hub
1.
Shift transfer lever to the ``2H'' position then move vehicle forward and rearward approximately three feet.
2.
Raise and support vehicle, then remove wheel and tire assemblies.
3.
Remove hub cap retaining bolts then the hub cap, Fig. 15.
4.
Remove housing assembly, snap ring and shims.
5.
Remove drive clutch assembly, inner cam and lock washer.
6.
Using a spring scale, adjust bearing preload to 3.31 lbs.
7.
Install lock washer with larger diameter of the tapered bore to the vehicle. If bolt holes in the lock plate are not aligned with the corresponding
holes in the nut, reverse the lock plate. If bolt holes are still out of alignment, turn nut enough to obtain alignment. Ensure screw is
fastened tightly so head is lower than surface of washer.
Fig. 16 Exploded view of manual locking hub assembly
Manual Locking Hub
1.
Shift transfer lever to the ``2H'' position and set free wheeling hub into ``FREE'' position.
2.
Raise and support vehicle, then remove wheel and tire assemblies.
3.
Remove housing assembly retaining bolts then the housing assembly Fig. 16.