Amigo 2WD V6-3.2L (1999)
8. Remove eight fixing bolts, then the cylinder head cover.
INSTALLATION
1. Install cylinder head cover.
-
Clean the sealing surface of cylinder head and cylinder head cover to remove oil and sealing materials completely.
-
Apply sealant (TB-1207B or equivalent) of bead diameter 2-3 mm at eight place of arched area of camshaft bracket on front and rear sides.
-
The cylinder head cover must be installed with in 5 minutes after sealant application to prevent hardening of sealant.
-
Tighten bolts to the specified torque.
Torque: 9 Nm (80 inch lbs.)
2. Install fuel injection harness bracket and tighten bolt to the specified torque.
Torque: 9 Nm (80 inch lbs.)