Amigo 4WD L4-2.3L (4ZD1) (1989)
Pick-Up Coil: Testing and Inspection
1.
Disconnect the battery ground cable, then remove distributor cap.
2.
Connect ohmmeter to either pick-up coil terminal and housing.
3.
Ohmmeter reading should be infinite. If not as specified, replace coil.
4.
Connect ohmmeter to both pick-up coil terminals, flex leads by hand at connector to locate intermittent opens.
5.
Resistance reading should be a constant unchanging value between 500--1500 ohms. If reading is not as specified, replace coil.