Amigo 4WD L4-2.3L (4ZD1) (1989)
becomes too great or less. Vehicle attitude will be adversely affected and will cause premature deterioration of rubber bushing.
1.
Measure height (B) of bushing center at rear side on crossmember, Fig. 2.
2.
Using a floor jack, hold the position of (A) wheel center 1.3 inches (33mm) higher than the rear lateral link bushing center as shown in Fig. 2.
3.
Torque the trailing link retaining bolts to 94 ft. lbs., and lateral link retaining bolts to 116 ft. lbs.
Vehicle Ride Height
Fig. 4 Ride height measurement points. 2WD models
Fig. 5 Ride height measurement points. 4WD models
Vehicle height is adjusted by means of a adjusting bolt on the control arms. Before adjusting trim height, check tire pressure and ensure vehicle is on
level ground.
1.
Loosen the nuts on the front strut bar for 2 wheel drive model.
2.
Measure vehicle as shown in Fig. 4 and 5.
3.
Subtract measurement (A) from measurement (B) to find vehicle ride height specification.
4.
Adjust bolt as necessary. On 4x2 Pickup models, dimension (Z) should be 2.05 inches, and on Amigo, 4WD Pickup and Rodeo models,
dimension (Z) should be 4.96 inches.