Amigo 4WD L4-2.3L (4ZD1) (1989)
/Page-519005.png)
3. Loosen the mounting member bolts (3).
4. Remove the mounting member from the side members (4).
5. Remove the transmission with the transfer case from the engine.
1) Remove the transmission nuts and bolts from the engine rear plate.
2) Carefully pull the transmission with the transmission jack toward the rear of the vehicle.
3) Operate the transmission jack to slowly lower the transmission.
Important Operations - Installation
Follow the removal procedure in the reverse order to perform the installation procedure. Pay careful attention to the important points during
the installation procedure.
Transmission with Transfer
1. Apply a thin coat of molybdenum disulfide grease to the top gear shaft spline.
2. Slowly raise the transmission jack until the front of the transmission is aligned with the rear of the engine. The slope of the engine and the
transmission must be the same.
3. Align the top gear shaft spline with the clutch driven plate spline.
4. Install the transmission to the engine. Tighten the transmission nuts and bolts to the specified torque.
Transmission Nut and Bolt Torque: ........................................................................................ 3.8 ± 0.8 (27.5 ± 5.8/37.2 ± 7.8) kg.m (lb.ft/N.m)
