Amigo 4WD L4-2.3L (4ZD1) (1989)
/Page-520045.png)
1) Cover the shaft spline with adhesive tape (1). This will prevent damage to the oil seal lip (2). Remove the tape from the output shaft after
installing the transfer case.
2) Apply recommend liquid gasket or its equivalent to the transfer case fitting surfaces.
3) Tighten the transfer case bolts to the specified torque a little at a time.
Transfer Case Bolt Torque: ...................................................................................................... 3.8 ± 0.8 (27.5 ± 5.8/39.24 ± 7.84) kg.m (lb.ft/N.m)
2. Transfer Counter Gear
3. Sub Gear
Apply chassis grease to the sub-gear and the counter gear thrust surfaces.
7. Bearing Inner Snap Ring
1) Select a snap ring that will allow the minimum axial play.
2) Use a pair of snap ring pliers to install the snap ring to the counter gear
16. Front Output Gear
17. Sub Gear
18. Belleville Spring
19. Spacer
