Amigo 4WD V6-3.2L (1999)
NOTE
This provides secondary insulation against the elements, and does not correct any loose or exposed connection(s).
14.
Cover the wrapped section of the harness with an additional supplied piece of harness protector and secure by wrapping the entire section again
with electrical tape.
15.
Remove and discard the remaining disconnected ABS sensor harness leading to the rear ABS sensor in rear differential housing, along with (4)
harness attaching clip bands from the attachment brackets.
16.
Route the new crimped connected repair ABS harness along the same path of the removed ABS sensor harness. Connect the rear ABS sensor to
this repair ABS harness (Figure 14), and attach all pre-installed attaching clips along the path (Figure 15), including the location on side of frame
near the frame-side bushing of upper-link. (Figure 16)