Amigo 4WD V6-3.2L (1999)
Engine Temperature Sensor: Service and Repair
Engine Coolant Temperature (ECT) Sensor
REMOVAL
NOTE: Care must be taken when handling the engine coolant temperature (ECT) sensor. Damage to the ECT sensor will affect proper operation of the
fuel injection system.
1. Disconnect the negative battery cable.
2. Drain the radiator coolant. Refer to Draining and Refilling Cooling System in Engine Cooling.
3. Disconnect the electrical connector.
4. Remove the ECT sensor from the coolant crossover.
INSTALLATION
1. Apply sealer or the equivalent to the threads of the ECT sensor.
2. Install the ECT sensor in the coolant crossover.
Tighten the ECT sensor to 30 N.m (22 lb ft.).