Ascender 2WD L6-4.2L (2003)
Hood Latch: All Technical Service Bulletins
Body - Rattling Sound From Hood
TSB SB04-11-S002
Rattle Sound From The Front Hood Of The Vehicle (Adjust Hood Latch)
Issue Date: March, 2004
Affected Vehicles
2003-2004 Isuzu Ascender
Service Information
Condition:
Some customers may comment on a rattle sound coming from the front of their vehicle.
Possible Cause:
The hood latch may have been improperly adjusted.
Correction:
Adjust the hood latch following the service procedure.
Service Procedure
1.
Open the hood and insert the prop rod.
2.
Remove the grille; refer to grille replacement in the Service Manual.
3.
Remove the left and right adjustable rubber bumpers. (see figure 1).
4.
Return the prop rod to its secured position and close the hood in a normal manner, engaging the primary latch.
5.
Loosen the three (3) hood latch bolts (see figure 2).
6.
Inspect the left and right side hood fit to the fender. Assure that the hood is at a minimum of 2 mm (0.078 in) below the fenders on both sides.
Apply downward pressure to the center of the hood above the latch in order to gain the 2 mm (0.078 in).