Ascender 2WD L6-4.2L (2003)
Ignition Lock: All Technical Service Bulletins
Ignition - Can't Remove Key From Ignition Lock
TSB SB07-04-S002
Issue Date: AUGUST 2007
Ignition Key Will Not Remove From Ignition Lock Cylinder
This Bulletin Supersedes SB05-04-S003
Affected Vehicles
2003-2008 Isuzu Ascender
Service Information
This bulletin is being revised to update model years.
Condition:
Some customers may comment that they are unable to remove the ignition key from the ignition cylinder.
Possible Cause:
The shifter boot may be caught/trapped in the shifter assembly mechanism.
Correction:
Reposition Shifter Boot.
Service Procedure
1.
Inspect the shifter boot for being caught/trapped in the shifter assembly.
^
If the shifter boot is NOT caught/trapped in the shift assembly, refer to Ignition Key Cannot Be Removed from the Ignition Lock Cylinder in
the Service Manual.
^
If the shifter boot IS caught/trapped in the shifter assembly, continue with the next step.
IMPORTANT:
DO NOT replace the complete shifter assembly for this condition. ONLY replace the shifter boot/handle if damaged by the shifter assembly.
2.
Reposition the shifter boot so that it is not caught/trapped in the shifter assembly.
Warranty Claim Information
Always refer to the Isuzu Service Policy Procedure Manual for specific details on warranty coverage and policies. Reference published Labor Time
Guide for claim processing, if applicable.
Disclaimer