Ascender 2WD L6-4.2L (2003)
Heated Glass Element: Procedures
Grid Line Repair
Grid Line Repair
Tools Required
J25070 Heat Gun - Capable of 260 °C (SOOT) or equivalent
Test Lamp
Rear Window Defogger Repair Kit or equivalent
Removal Procedure
CAUTION: To avoid personal injury:
-
Do not allow the repair material to come in contact with skin or eyes and avoid breathing vapors.
-
Do not use near sparks or open flame.
1. Disconnect the electrical connector.
2. Inspect the rear window grid lines.
3. Ensure that the rear window is at room temperature.
4. Inspect the grid line area that you will repair. Verify that the area is dry and free from contaminates.
5. Dampen a cloth with isopropyl alcohol. Use the damp cloth in order to wipe the grid line area clean.
Installation Procedure
IMPORTANT:
-
Ensure that the grid line repair material is not beyond the expiration date.
-
Repair decal or tape must be used in order to control the width of the repair area.
-
If the repair decal is used, verify that the die-cut metering slot is the same width as the grid line.
-
Thoroughly stir the grid line repair material until a uniform color appears.
-
Verify that there are no air bubbles in the grid line repair material in the repair area.
1. Use a grease pencil in order to mark the grid line break (2) on the outside of the rear window with a grease pencil.
2. Using equivalent to repair the grid lines.
Apply the grid line repair (2) decal or 2 strips of the tape above and below the repair area.
3. Use the brush (3) in order to spread the grid line repair material (1). Ensure that the repair material covers all of the areas of the cut out.
NOTE: The grid line repair material must be cured with heat. To avoid heat damage to the interior trim, protect the trim near the repair area
where heat is to be applied.
