Ascender 2WD V8-5.3L (2004)
2. Connect the RF side impact module yellow 2-way connector (1) located under the passenger seat.
3. Install the CPA to the RF side impact module yellow 2-way connector (1) located under the passenger seat.
4. Install the AIR BAG Fuse to the fuse block (1) located in the underhood fuse block.
5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
5.1.
The AIR BAG indicator will flash 7 times.
5.2.
The AIR BAG indicator will then turn OFF.
6. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
