Ascender 2WD V8-5.3L (2004)
9. Remove the upper intermediate shaft from the vehicle.
Installation Procedure
1. Install the upper intermediate shaft to the vehicle.
2. Connect the upper intermediate shaft to the steering column.
Notice: Refer to Fastener Notice in Service Precautions.
Important: The upper intermediate shaft to the steering column pinch bolt must be installed in the same direction it was removed or the pinch bolt
will contact the steering column housing.
3. Install the upper intermediate shaft to the steering column pinch bolt and nut.
^
Tighten the upper intermediate shaft to the steering column pinch bolt nut to 50 Nm (37 ft. lbs.).
4. Connect the upper intermediate shaft to the lower intermediate shaft.
5. Install the upper intermediate shaft to the lower intermediate shaft pinch bolt.
^
Tighten the upper intermediate shaft to the lower intermediate shaft pinch bolt to 50 Nm (37 ft. lbs.).
Important: The upper intermediate shaft boot must completely cover the white insert of the lower intermediate shaft boot to ensure proper
sealing.
