Ascender 4WD V8-5.3L (2004)
59. Twist together, bend, and tape the remaining connector wire lead to the remaining deployment wire.
60. Route the deployment harness out of the vehicle's passenger side.
61. Stretch the two driver side harnesses to full length.
62. Stretch the two passenger side harnesses to full length.
63. Completely cover the windshield and front door window openings with a drop cloth.
64. Place a power source, 12 V minimum/2 A minimum, i.e., a vehicle battery, near the shorted ends of the passenger side deployment harnesses.
65. Separate the two ends of the IP module deployment harness wires.
66. Connect the IP module deployment harness wires to the power source in order to deploy the IP module.
67. Disconnect the IP module deployment harness wires from the power source.
68. Separate the two ends of the RF side impact module deployment harness wires.
69. Connect the RF side impact module deployment harness wires to the power source in order to deploy the RF side impact module.