Axiom 4WD V6-3.5L (2004)
Coolant Temperature Sensor/Switch (For Computer): Description and Operation
Engine Coolant Temperature (ECT) Sensor
The engine coolant temperature (ECT) sensor is a thermistor (a resistor which changes value based on temperature) mounted in the engine coolant
stream. Low coolant temperature produces a high resistance of 100,000 ohms at -40° C (-40 °F). High temperature causes a low resistance of 78 ohms at
130 °C (266 °F). The ECM supplies a 5-volt signal to the ECT sensor through resistors in the ECM and measures the voltage. The signal voltage will be
high when the engine is cold and low when the engine is hot. By measuring The voltage, the ECM calculates the engine coolant temperature. Engine
coolant temperature affects most of the systems that the ECM controls.
The Tech 2 displays engine coolant temperature in degrees. After engine start-up, the temperature should rise steadily to about 85 °C (185 °F). It then
stabilizes when the thermostat opens. If the engine has not been run for several hours (overnight), the engine coolant temperature and intake air
temperature displays should be close to each other. A hard fault in the engine coolant sensor circuit will set DTC P0117 or DTC P0118.