Axiom 4WD V6-3.5L (2004)
Engine Control Module: Service and Repair
Control Module Programming And Relearning
Service Programming System (SPS)
The procedure to program the control unit by using the Service Programming System (SPS) software contained in TIS2000 is explained below.
NOTE: If the Engine Control Module (ECM) was programmed, the Immobilizer System must be linked to the ECM: Refer to section 11 "Immobilizer
System-ECM replacement" for the ECM/Immobilizer linking procedure.
IMPORTANT: Perform the following checks before attempting to program the control unit:
-
The Tech 2 PCMCIA card is programmed with the latest software release.
-
The latest release of TIS2000 is loaded on the PC.
-
The vehicle battery is fully charged.
-
The control unit to be programmed is connected to the vehicle.
1. Preparations of TIS 2000
1. Connect Tech 2 to P/C.
2. Check to see if Hardware Key is plugged into Port.
3. Activate TIS 2000 by P/C.
4. On the activating screen of TIS2000, choose "Service Programming System"
5. On the screen of "Diagnostic Tester and Processing Program Selection", choose the one that will comply with the following.
-
Diagnostic tester in use
-
New programming by the existing module or new programming by the replaced/new module.
-
Fixing position of the control unit.
6. Upon completion of the selection, push the button of "Continue".
2. Demand of Data
1. Connect Tech 2 to the vehicle. When activated by turning on the power of Tech 2, push the "Enter" switch.
2. Turn on the ignition switch (without starting the engine)
3. In the main menu of Diagnostic Tester, push "F1: Service Programming System (SPS)".
4. Push "F0: Request Info" of Tech 2.
