Axiom 4WD V6-3.5L (2004)
Starter Motor: Service and Repair
Removal and Installation
REMOVAL
1. Battery ground cable.
2. Disconnect Heated O2 Sensor connector (1).
3. Remove exhaust front left pipe (2).
4. Disconnect starter wiring connector from terminals "30" (1) and "50" (2).
5. Remove starter assembly mounting bolts on inside and outside (3).
6. Remove starter assembly (4) toward the bottom of engine.
INSTALLATION
1. Install starter assembly(4).
2. Install mounting bolts and tighten bolts to specified torque (3).
Torque: 40 Nm (30 lb-ft)