Hombre L4-2.2L CPC (1996)
Typical Weather Pack Connector And Terminal
Follow the steps below to repair Weather Pack(R) connectors.
Step 1: Separate the connector halves.
Step 2: Open secondary lock. A secondary lock aids in terminal retention and is usually molded to the connector.
Step 3: Grasp the lead and push the terminal to the forward most position. Hold the lead at this position.
Step 4: Insert the Weather Pack(R) terminal removal tool into the front (mating end) of the connector cavity until it rests on the cavity shoulder.
Step 5: Gently pull on the lead to remove the terminal through the back of the connector.
NOTE: Never use force to remove a terminal from a connector.
Step 6: Inspect the terminal and connector for damage. Repair as necessary (refer to Terminal Repair).
Step 7: Re-form the lock tang and reseat terminal in connector body.
Step 8: Close secondary locks and join connector halves.
Terminal Repairs
Terminal Repair
The following repair procedures can be used to repair Push-to-Seat, Pull-to-Seat or Weather Pack(R) terminals. Some terminals do not require all steps
shown. Skip those that don't apply. The Terminal Repair Kit (J 38125-A) contains further information.