Hombre S Regular Cab 4WD V6-4.3L (1999)
Range: 0.0 - 16.0 volts
The voltage value that displays refers to the battery system voltage measured by the BCM on CKT 1140.
Content Theft Lamp
Range: ON/OFF/FLASHING
The security lamp turns ON for 15 seconds and then turns OFF when you open a door by using the handle or the key fob. The security lamp also
displays ON STEADY for 3 seconds and then turns OFF when the ignition switch turns from the OFF position to the RUN position. The security
telltale has the following 3 states:
-
OFF
-
ON STEADY
-
FLASHING
If the IPC is unable to communicate with the BCM, the security telltale displays ON STEADY and the Passlock (TM) system functions. The security
telltale goes to FLASHING mode momentarily and then displays ON STEADY for approximately 10 minutes if the vehicle is in the lockout cycle. The
passlock (TM) system requires 3 consecutive lockout cycles in order to complete the 30 minute learn procedure for a changed component. Refer to
Theft Deterrent on the theft deterrent system.
See: Accessories and Optional Equipment/Antitheft and Alarm Systems
Without Scan Tool
You may NOT clear a DTC from the memory of the BCM by performing either of the following actions:
-
Disconnecting the battery
-
Disconnecting the BCM electrical connectors
Perform one of the following steps in order to clear a DTC from the memory of the BCM:
-
Use the scan tool.
-
Perform 100 concurrent ignition cycles without the fault recurring.
You must clear the DTCs from the BCM after performing a repair. You may also clear the DTCs from the BCM in order to ensure that a malfunction
will not occur again. If the fault still exists, the DTC will reset after clearing the DTCs. If any current non-Passlock (TM) system related DTCs exist,
diagnose those DTCs before clearing the Passlock (TM) DTCs. When the Passlock (TM) DTCs are cleared, the BCM DTCs will also be cleared.
With Generic Scan Tool
ISUZU does not provide a procedure for clearing diagnostic trouble codes with a generic scan tool.
With TECH 2
You may NOT clear a DTC from the memory of the BCM by performing either of the following actions:
-
Disconnecting the battery
-
Disconnecting the BCM electrical connectors
Perform one of the following steps in order to clear a DTC from the memory of the BCM:
-
Use the scan tool.
-
Perform 100 concurrent ignition cycles without the fault recurring.
You must clear the DTCs from the BCM after performing a repair. You may also clear the DTCs from the BCM in order to ensure that a malfunction
will not occur again. If the fault still exists, the DTC will reset after clearing the DTCs. If any current non-Passlock (TM) system related DTCs exist,
diagnose those DTCs before clearing the Passlock (TM) DTCs. When the Passlock (TM) DTCs are cleared, the BCM DTCs will also be cleared.