Hombre S Regular Cab 4WD V6-4.3L (1999)
1. Install the brake pads.
Important: Lift the inner edge caliper boot next to the piston. Press out any trapped air. The boot must lay flat below the level of the
piston face.
2. Install the caliper over the rotor and into the anchor bracket.
3. Install the guide pin bolts.
Tighten
Tighten the bolt to 31 N.m (23 lb ft).
Notice: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
Disassembly and Reassembly
Brake Caliper Overhaul - Rear
Disassembly Procedure
1. Drain all the brake fluid from the caliper.