Hombre S Regular Cab 4WD V6-4.3L (1999)
Engine Mount: Service and Repair
Engine Mount Replacement (Front)
Removal Procedure
Notice: Broken or deteriorated mounts can cause misalignment and destruction of certain drive train components. When a single mount breaks, the
remaining mounts are subjected to abnormally high stresses.
1. Raise the vehicle.
2. Remove the underbody shields, if equipped.
3. Remove the engine mount through-bolt and nut for the side being replaced.
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Lifting
the engine in an unapproved manner may cause component damage.
4. Using a jack on the square tab (left side shown) at the rear of the engine block, raise the engine. In order to access the square tab on the right side
remove the starter.
5. Raise the engine only enough to remove the engine mount.