Hombre S Regular Cab 4WD V6-4.3L (1999)
11. Remove the accelerator and the cruise control cable bracket from the throttle bracket. Leave the accelerator and cruise control cables and the
wiring harness on the bracket.
12.Remove the following electrical connectors:
-
The fuel meter body assembly
-
The EVAP canister purge solenoid valve
-
The idle air control (IAC) motor
-
The throttle position (TP) sensor
-
The A/C compressor high pressure switch, if equipped
-
The A/C clutch switch, if equipped
-
The exhaust gas recirculation (EGR) valve
-
The engine coolant temperature (ECT) sensor
-
The ignition coil
-
The ignition control module (1CM)
13. Remove the engine wiring harness from the retainers.
14. Move the engine wiring harness aside.
16. Remove the distributor.
16. Remove the exhaust gas recirculation (EGR) valve inlet pipe from the intake and exhaust manifold.
17. Disconnect the fuel supply and return pipes at the rear of the intake manifold.
