Hombre S Regular Cab 4WD V6-4.3L (1999)
1. Install a NEW crankshaft rear oil seal housing gasket.
Important: When installing a NEW crankshaft rear oil seal housing the crankshaft rear oil seal will come with the housing. Use the following
procedure. Refer to Crankshaft Rear Oil Seal and Housing Replacement (Seal) if reusing the crankshaft rear oil seal housing.
2. Install the NEW crankshaft rear oil seal housing with the crankshaft rear oil seal to the engine block using the following procedure.
Important: Do not oil or grease the crankshaft rear oil seal lip.
1. Leave the sleeve in the crankshaft rear oil seal and use the sleeve as a guide to ease the seal lip over the end of the crankshaft.
2. Push the crankshaft rear oil seal housing with the crankshaft rear oil seal, fully onto the crankshaft until the housing is against the gasket and
the engine.
3. Install the three bolts and the one nut to the crankshaft rear oil seal housing.
Tighten the crankshaft rear oil seal housing bolts and nut to 12 N.m (106 lb in).
4. Install the engine flywheel.
5. Install the transmission assembly.
6. Install the oil pan.
Crankshaft Rear Oil Seal and Housing Replacement (Seal)
Removal Procedure
1. Remove the transmission assembly.
2. Remove the flywheel.
3. Remove the crankshaft rear oil seal from the crankshaft rear oil seal housing
Insert a suitable tool into the access notches and then carefully pry the crankshaft rear oil seal from the crankshaft rear oil seal housing
4. Discard the crankshaft rear oil seal.
Installation Procedure
Tools Required
-
J 35621-B Rear Seal Installer
Important: Do not oil or grease the crankshaft rear oil seal lip or the crankshaft.