Hombre S Regular Cab 4WD V6-4.3L (1999)
9. Ensure that the stake size is only one-half the area of the punch tip. Ensure that the stake is only approximately 0.28-0.35 mm (0.010-0.015 in)
deep.
10. With the compressor mounted to the J 34992, position the pulley rotor (1) and bearing assembly on the front head.
11. Position the J 33017 and the J 33023-A directly over the inner race of the bearing.
12. Position the J 8433-1 on the J 33023-A.
13. Assemble the 2 through bolts and washers through the puller bar slots.
14. Thread the bolts into the J 34992.Ensure that the thread of the through bolts engages the full thickness of the J 34992.
15. Tighten the center screw in the J 8433-1 in order to force the pulley rotor and bearing assembly onto the compressor front head.
If the J 33017 slips off direct in-line contact with the inner race and bearing, Perform the following steps:
1. Loosen the J 8433-3.
2. Realign the installer and the pilot in order to ensure that the J 33017 properly clears the front head.
