Hombre S Regular Cab 4WD V6-4.3L (1999)
Fuel Gauge Sender: Service and Repair
REMOVAL
1. CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
Disconnect the negative battery cable.
2. Relieve the fuel system pressure.
3. Drain the fuel tank.
4. Remove the fuel tank.
5. Remove the fuel sender assembly by using the J 39765 in a counter clockwise motion.
DISASSEMBLE PROCEDURE
1. Note the position of the fuel pump strainer on the fuel pump.
2. Support the pump with one hand and grasp the strainer with the other hand.
3. Rotate the strainer in one direction and pull OFF the pump. Discard the strainer after inspection.
4. Inspect the fuel pump strainer. Replace the strainer if it has contaminates and clean the fuel tank.
5. Inspect the fuel pump inlet for dirt and debris. If found, Replace the pump.
ASSEMBLE PROCEDURE
NOTE: Do not fold or twist the strainer when installing the sending unit. This action restricts fuel flow.
1. Push on the outer edge of the ferrule until fully seated.
2. Support the pump with one hand and position the new pump strainer on pump in the same position as noted during disassembly.
INSTALLATION
