Hombre S Regular Cab 4WD V6-4.3L (1999)
3. Ensure that the cable seal is kept on the terminal side of the splice.
4. Insert the wire into the back of the connector Body. Push until the terminal locking tang locks into the connector Body.
5. Install the TPA, CPA and/or the secondary locks.
Weather Pack Connectors
The following is the proper procedure for the repair of Weather Pack Connectors.
-
Separate the connector halves (1).
-
Open the secondary lock. A secondary lock aids in terminal retention and is usually molded to the connector (1).
-
Grasp the wire and push the terminal to the forward most position. Hold the wire in this position.
-
Insert the Weather Pack TM terminal removal tool into the front (mating end) of the connector cavity until it rests on the cavity shoulder (1).
-
Gently pull on the wire to remove the terminal through the back of the connector (2).
Important: Never use force to remove a terminal from a connector.
-
Inspect the terminal and connector for damage. Repair as necessary. Refer to Repairing Connector Terminals.
-
Reform the lock tang (2) and reset terminal in connector Body.
-
Close secondary locks and join connector halves.
-
Verify that circuit is complete and working satisfactorily.
-
Perform system check.
Repairing Connector Terminals
Use the following repair procedures in order to Repair the following terminals:
-
Push to seat terminals
