Hombre S Regular Cab 4WD V6-4.3L (1999)
4. Reconnect the turn signal and multifunction switch assembly connector to the SRS coil assembly connector.
5. Attach the wire harness assembly (1) to the steering column with new wire harness straps (2).
6. Install the upper and lower shrouds.
Turn Signal and Multifcn Sw Assembly - Disassemble (Floor Shift)
Disassembly Procedure
1. Remove the upper and lower shrouds. Refer to Shrouds, Shift Lever Seal - Disassemble (Floor Shift).
2. Remove the wire harness straps (2) from the wire harness assembly (1) and the steering column.
3. Disconnect the turn signal and multifunction switch assembly connector from the SRS coil assembly connector.
4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
