Hombre S Regular Cab 4WD V6-4.3L (1999)
4.
Install the proper Installation Mandrel on the threaded portion of the Installation Tool (see figure 2).
5.
Using the Installation Tool, place the manifold into the fixture of the tool.
A.
Lubricate the applicable filter screen with refrigerant lubricant.
B.
Ensure that you are on the suction side of the air conditioning manifold.
C.
Place the filter screen straight into the bore before proceeding.
D.
Using a 9/16 in wrench, turn the bolt of the Installation Tool clockwise, pressing the filter screen into the bore. The filter screen must be
flush with or slightly below the bore (see figure 3).
6.
Reinstall the manifold on the rear of the air conditioning compressor. Make sure to tighten to the correct specifications (see figure 3).
NOTE:
Be sure to clean the appropriate surface before applying the Notification Label.
7.
Included in the kit is a bright yellow Notification Label with the following message: ATTENTION! Suction Line Screen Installed. It is very
important that you apply this label to the manifold, the suction line, or some other appropriate, highly visible location.
