Hombre S Regular Cab 4WD V6-4.3L (1999)
1. Line up the square-cut hole in the vane wheel for the camshaft position (CMP) sensor.
2. Insert the sensor into the housing.
NOTE: Refer to Fastener Note in Service Precautions.
3. Install two NEW screws for the camshaft position (CMP) sensor.
Tighten
Tighten the screws to 2.2 N.m (20 lb in).
4. Identify the correct rotor mounting position.
-
At the rotor screw holes(1).
-
At the rotor locator pin holes(2).
