Hombre S Regular Cab 4WD V6-4.3L (1999)
Fuel Tank Pressure Sensor: Service and Repair
Removal Procedure
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Relieve the fuel pressure.
3. Drain the fuel tank.
4. Remove the fuel tank.
5. Disconnect the fuel tank pressure sensor electrical connector.
6. Remove the fuel tank pressure sensor (1) from fuel sender assembly (2)
Installation Procedure
1. Install the fuel tank pressure sensor (1) on the fuel sender assembly (2).
2. Connect the fuel tank pressure sensor electrical connector.
3. Install the fuel tank.
4. Refill the fuel tank.
5. Install the fuel filler cap.
6. Connect the negative battery cable.
7. Inspect for leaks.
1. Turn the ignition switch ON for 2 seconds.
2. Turn the ignition switch OFF for 10 seconds.
3. Turn the ignition switch ON.
4. Inspect for fuel leaks.
