Hombre S Regular Cab 4WD V6-4.3L (1999)
2.
Remove the Positive Crankcase Ventilation (PCV) clean air tube from the air inlet tube and set aside.
3.
Remove the bonnet and inlet tube from the throttle body.
4.
Remove the brake booster vacuum hose and connector from the intake manifold.
5.
Remove the electrical connector from the CSFI fuel metering body.
6.
Remove ignition wires 1, 3, 5 from the distributor cap (see figure 1).
7.
Remove the fuel line bolt (4) at the rear of the intake manifold (see figure 1).
8.
Relieve the fuel system pressure at the service fitting on the fuel line. Use a shop towel to contain any fuel that may exit the service fitting.
9.
Remove the nuts (1) and clamp (2) from the fuel pipe (see figure 2).
10.
Remove the fuel pipes from the metering body. Be careful not to disturb the 0-rings, washer, and spacer in the metering body.
