Hombre S Regular Cab 4WD V6-4.3L (1999)
8.
Relieve the fuel system pressure at the service fitting on the fuel line. Use a shop towel to contain any fuel that may exit the service fitting.
9.
Remove the nuts (1) and clamp (2) from the fuel pipe. (Figure 2)
10.
Remove the fuel pipes from the metering body. Be careful not to disturb the 0-rings, washer, and spacer in the metering body. (Figure 2)
11.
Install the J 44466-12 (2) and the J 44466-13 (1) to the metering body and tighten. Make sure that the fuel pipe 0-rings, washer, and spacers are
present and in their proper position. (Figure 3)
12.
Install the J 44466-11 (4), clamp (2), and J 44466-13 (1) to the fuel pipe and tighten. (Figure 4)