Hombre S Regular Cab 4WD V6-4.3L (1999)
alignment.
-
In order to correct this condition, remove the distributor and reinstall it.
NOTE: Refer to Fastener Note in Service Precautions.
8. Install the distributor mounting clamp bolt.
Tighten
Tighten the distributor clamp bolt to 25 N.m (18 lb ft).
9. Install the distributor cap.
10. Install two NEW distributor cap screws.
Tighten
Tighten the screws to 2.4 N.m (21 lb in).
11. Install the electrical connector to the distributor.
12. Install the spark plug wires to the distributor cap.
13. Install the ignition coil wire.
The wire must not touch anything like the dip stick, rubbing will make a ground/short after time of use.
IMPORTANT: If the Malfunction Indicator lamp is turned on after installing the distributor, and a DTC P1345 is found, the distributor has been
installed incorrectly.
14. Refer to Installation Procedure 2 if Malfunction Indicator lamp is turned on after installing the distributor.
15. Install the engine cover, if equipped.
