Hombre S Regular Cab 4WD V6-4.3L (1999)
Transfer Case Actuator: Service and Repair
Motor/Encoder Replacement
Removal Procedure
1. Remove the transfer case shield.
2. Remove the transfer case wiring harness connectors from the motor/encoder.
3. Remove the bolts that secure the motor/encoder to the transfer case.
Installation Procedure
1. Position the motor/encoder to the transfer case.
Important:
Do not use steel bolts to secure the encoder/motor to the transfer case.
Any encoder/motor bolts that are worn or broken must be replaced with the correct G/M replacement bolts. A steel bolt will cause accelerated
corrosion that will destroy the integrity of the magnesium case.
2. Install the bolts securing the motor/encoder to the transfer case.
Tighten
Tighten the motor/encoder bolts to 37 N.m (27 lb ft).
-
Remove all gasket material remaining from the motor/encoder.
-
Ensure the motor/encoder aligns properly with the transfer case interior shifting components.
-
Align the motor/encoder mating surface detent with the transfer case mating surface detent.
3. Install the wiring harness connector to the motor/encoder.
4. Install the transfer case shield.