Hombre S Regular Cab 4WD V6-4.3L (1999)
Important: After front probing any connector, check for terminal damage. If terminal damage is suspected, check for proper terminal contact.
When front probing connectors use a mating terminal adapter from the J 35616-A Connector Test Adapter Kit. Using the proper adapters ensures that
proper terminal contact integrity is maintained.
Frontprobe connector terminals only when specifically required in diagnostic procedures. Because front probing can be a source of damage to connector
terminals. Use extra care in order to avoid deforming the terminal, either by forcing the test probe too far into the cavity or by using too large of a test
probe.
Backprobe
Important:
-
Do not backprobe a sealed connector.
-
After backprobing any connector, check for terminal damage. If terminal damage is suspected, check for proper terminal contact.
Symptom Diagnostic Example
The following is an example of a symptom and the correct course of action taken by the technician.
Important: Research for possible bulletins, DTCs and the vehicle's service history. Also, thoroughly screen the customer regarding the problem in order
to complete the repair of the vehicle and completely satisfy the customer when a DTC or a symptom diagnosis is not available.
Verify the Customer Concern, Check the Problem
Customer complaint is the headlamps are inoperative. Verify the normal operating procedure of the circuit and the components that share that circuit.
Refer to Strategy Based Diagnosis.
Review the Headlamps Electrical Schematic (Preliminary Checks)
Review the schematic, it is essential to understand how a circuit should work before trying to figure out why it doesn't. After understanding how a circuit
should operate, read the schematic again, this time keeping in mind what has been learned by operating the circuit. Since both the low beam headlamps
are inoperative, ensure that the following components are operating properly.
-
The headlamp Switch.
-
The YEL wire.
-
Low contacts of the Headlamp Dimmer Switch
-
C100 terminal 1E.
-
The TAN wires.
-
Grounds G105 and G109.
Refer to Strategy Based Diagnosis.
Perform the System Check
The system check indicates that the low beam headlamps operate when the high beam switch is in high.
Also, the high beam indicator illuminates but neither high beam headlamp operates.
Check for Bulletins
Utilizing a combination of Techline tools and the information accumulated from the Preliminary Checks, check for bulletins.
Isolate the Root Cause
At this point analyze and (diagnose the problem), and develop text. Since the high beam indicator illuminated when the headlamp dimmer switch was in
the high position, the high contacts of the headlamp dimmer switch and the LT GRN wire between the headlamp dimmer switch and C100 are good.
At this point, it is extremely unlikely that the high beam filaments in the RH headlamp are both open or that both headlamp connections are bad. The
cause must be a bad connection at C100 or an open in the LT GRN wire between C1OO and the RH headlamp.
