Hombre S Regular Cab 4WD V6-4.3L (1999)
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed. Failure to follow the
procedures in the order listed may result in personal injury.
1. Turn the ignition switch to the OFF position.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove all loose objects from the front seats.
5. Disconnect the supplemental restraint steering wheel module yellow 2-way connector. Refer to Supl Rst Steering Wheel Module Replacement.
6. Cut the yellow 2-way harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
7. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
8. Cut two 4.6 M (15 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. Use these wires to fabricate the driver deployment
harness.
9. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
