Hombre S Regular Cab 4WD V6-4.3L (1999)
16. Connect the deployment harness to the supplemental restraint steering wheel module yellow 2-way connector.
17. Route the deployment harness out of the vehicle's driver side.
18. Disconnect the supplemental restraint IP module yellow 2-way harness connector.
19. Cut the harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
20. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
21. Cut two 6.1 M (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the passenger
deployment harness.
