Hombre S Regular Cab 4WD V6-4.3L (1999)
37. Disconnect the driver deployment harness wires from the power source.
38. Separate the two ends of the passenger deployment harness wires.
39. Connect the passenger deployment harness wires to the power source in order to deploy the supplemental restraint IP module.
40. Disconnect the passenger deployment harness wires from the power source.
41. Twist together one end of each wire on the driver deployment harness in order to short the wires.
42. Twist together one end of each wire on the passenger deployment harness in order to short the wires.
43. Remove the drop cloth from the vehicle.
44. Disconnect both harnesses from the vehicle.
45. Discard the harnesses.
46. Scrap the vehicle in the same manner as a non-SRS equipped vehicle.
47. If one or both of the modules did not deploy, perform the following steps:
1. Remove the undeployed module(s) from the vehicle. Refer to Supl. Rst Steering Wheel Module Replacement and Supl. Rst Instrument Panel
Module Replacement
2. Temporarily store the module(s).
3. Call the Technical Assistance Group for further assistance.
Deployed Air Bag Handling
When handling a deployed air bag assembly, a face shield and rubber gloves should be worn. Vehicle interior and A/C, vent, defroster and heater ducts
should be vacuumed. If sinus or throat irritation is encountered during air bag removal, exit vehicle and breathe fresh air. If skin irritation is encountered,
flush effected area with cool water. If sinus, throat, skin or any other type of irritation continues, consult a physician. After handling a deployed air bag
assembly, wash hands and rinse thoroughly with water.
An air bag that has been deployed should be removed from the vehicle. Prior to removing a deployed air bag assembly, place tape over air bag exhaust
vents. After unit has been removed, it should be placed in a heavy duty plastic bag and sealed securely. The sealed plastic bag should then be placed with
automotive scrap. An air bag assembly that has not been deployed, must be deployed prior to disposal.
