Hombre S Regular Cab 4WD V6-4.3L (1999)
Power Steering Pump: Service and Repair
Power Steering Pump Replacement (4.3L)
Removal Procedure
Tools Required
-
J 25034-B Power Steering Pump Pulley Remover
1. Remove the upper fan shroud.
2. Remove the Drive belt.
3. Remove the fan clutch from the water pump.
4. Install J 25034-B to the power steering pump pulley.
Ensure that the pilot bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
5. Hold the pilot bolt.
6. Turn the nut clockwise.
7. Remove the power steering pump pulley.
8. Raise and suitably support the vehicle.
9. Remove steering Linkage shield.
10. Place a drain pan below the pump.
11. Disconnect the power steering pressure hose from the power steering pump.
12. Lower the vehicle.
13. Disconnect the power steering return hose from the power steering pump.