Hombre S Regular Cab 4WD V6-4.3L (1999)
Important: If the original preload torque was less than 3 inch-pounds, reset the torque specification to 3 - 5 inch-pounds.
5. Measure the torque required to rotate the pinion. Compare this with the torque recorded earlier. Continue to tighten and measure a little at a time
until the same preload is achieved.
6. Align the propeller shaft with the alignment marks made previously. Use J 8614-01 in order to hold the pinion flange.
7. Install the propeller shaft to the pinion flange.
8. Install the bolts and retainers.
Tighten
Tighten the bolts to 45 N.m (33 lb ft).