Hombre S Regular Cab 4WD V6-4.3L (1999)
16. Position the outboard end of the halfshaft assembly (1) in J 41048.
17. Align the swag clamp (2) within J 41048.
18. Place the top half of the J 41048 on the bottom half.
19. Check to make sure there are no pinch points on the boot before proceeding with procedures.
20. Insert the bolts (2). Tighten the bolts (2) by hand until snug.
21. Align the following items:
-
The boot
-
The housing
-
The swag clamp
Tighten
Each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
22. Loosen the bolts.
23. Separate the dies.