Hombre S Regular Cab 4WD V6-4.3L (1999)
Important: Ensure that the rings are fully seated.
15. Install the spacer ring (2) and spider assembly (1) onto the halfshaft bar (3).
16. Install the other spacer ring in the groove at the end of the halfshaft bar. Ensure that the rings are fully seated.
17. Pack the boot and housing with the grease supplied in the kit. The amount of grease supplied in this kit has been pre-measured for this application.
18. Place the large retaining clamp (2) on the boot.
19. Place the housing (1) and the tripot trilobal bushing over the spider assembly (3).
20. Install the boot onto the tripot trilobal bushing.
21. Check the inboard stroke position.
