Hombre S Regular Cab 4WD V6-4.3L (1999)
18. Remove the inner race from the cage by rotating the inner race upward.
19. Thoroughly degrease all of the CV joint parts.
20. Check the outer CV joint assembly for unusual wear, cracks, or other damage. Replace any damaged parts.
21. Clean the halfshaft bar. Use a wire brush to remove any rust in the boot mounting area (grooves).
Assembly Procedure
Tools Required
-
J 35910 Seal Clamp Tool
-
J 41048 Swage Clamp Tool
Important: Replace the joint assembly if necessary.
1. Inspect all of the parts for unusual wear, cracks, or other damage.
2. Put a light coat of the recommended grease on the inner and the outer race grooves.
3. Insert the inner race into the cage by rotating the inner race downward.
4. Hold the inner race (1) at 90 degrees to the centerline of the cage.