Hombre S Space Cab 2WD V6-4.3L (2000)
5. Bleed the caliper, if separated from the brake hose in removal. Refer to Hydraulic Brake System Bleeding.
6. Install the tire and wheel assembly.
7. Remove the safety stands and lower the vehicle.
8. With the engine running, firmly pump the brake pedal three times.
9. Inspect the brake system for leaks.
Inspection
After removing the brake caliper assembly from the vehicle, perform the following inspection procedure:
-
Inspect the inside of the caliper assembly for signs of brake fluid leakage. If you find leakage, overhaul the caliper assembly.
-
Inspect the dust boot for damage. If you find damage, replace the boot.
-
Inspect the casting for damage. If you find damage, replace the caliper.
-
Inspect the mounting bolts and sleeves for damage or corrosion. Replace the damaged or corroded bolts and sleeves. Do not attempt to polish
away the corrosion.
Single Piston
Disassembly Procedure
1. Drain all the brake fluid from the caliper.
Caution: Do not place your fingers in front of the piston in order to catch or protect the piston while applying compressed air. This could
result in serious injury.
Notice: Use just enough air pressure to ease the piston out of the bore. You can damage a blown-out piston even with the padding.
2. Pad the interior of the caliper with clean shop towels.
3. Remove the piston from the caliper bore.
4. Remove the boot from the caliper bore. Do not scratch the housing bore.
