Hombre S Space Cab 2WD V6-4.3L (2000)
4. Remove J 29193 or J 29194 from inner tie rod ball stud.
5. Install the new nut to the inner tie rod ball stud.
Tighten
Tighten the inner tie rod ball stud to relay rod nut to 47 Nm (35 ft. lbs.).
6. Connect the outer tie rod ball stud to the steering knuckle. Ensure that the seal is on the stud.
Notice: Refer to Fastener Notice In Service Precautions.
7. Seat the taper using J 29193 or J 29194.
Tighten
Tighten J 29193 or J 29194 to 54 Nm (40 ft. lbs.).
8. Remove J 29193 or J 29194 from outer tie rod ball stud.
9. Install the nut to the outer tie rod ball stud.
Tighten
Tighten the outer tie rod ball stud to the steering knuckle nut to 53 Nm (39 ft. lbs.).
Important: Do not back the nut off in order to align the cotter pin hole. Advance the nut in order to align the nut slot with the cotter pin hole.
10. Install the new cotter pin to the outer tie rod stud nut.
11. Spread the cotter pin ends.
12. Lower the vehicle.
13. Adjust the front toe. Refer to Front Toe Adjustment in Wheels, Tires and Alignment.
